The First Program - WAGO I/O-SYSTEM 750 510 376 07 Quick Start Manual

2.3 The First Program

Prerequisite:
The WAGO-I/O-PRO CAA software (CoDeSys) has to be installed correctly
and started.
You can start a new project via
Example:
Before programming the 750-841 controller, select the controller in the "Tar-
get Settings" window.
Fig. 9: Target settings
Please select the "WAGO_750-841" target in this window.
In use of WAGO-I/O-PRO CAA, starting from version 2.3.9.3, you select the
target system "WAGO_750-841_(FW12 -...)", if the WAGO Ethernet Control-
ler 750-841 has already the firmware version 13.
This is to recognize on the basis of the manufacturing number, look at the 5th
and 6th number.
Further information
Detailed Information about the manufacturing number, please refer to the
manual „Ethernet TCP/IP 750-841".
You can find this manual on the CD-ROM „WAGO-I/O-PRO CAA"
(759-911), on the CD-ROM „ELECTRONICC Tools & Docs"
(Item.-No.: 0888-0412/0001-0101) and also on the Internet under:
www.wago.com
Then confirm the selected target with "OK" in the dialog box above.
A POU can now be created in the following dialog box. In this example, a new
"PLC_PRG" is created in "ST" programming language (Fig. 10).
WAGO-I/O-SYSTEM 750
ETHERNET StarterKit 2
The First Program
File New.
Quick Start • 13