Figure 26: Dialog Window Detail: Setting For Channel 1; Figure 27: Channel Selection Dialog Window - WAGO 750-482/000-001 Manual

2ai 4-20ma hart namur ne43, 2-channel analog input, 4 ma … 20 ma hart, namur ne43

Table of Contents

Commissioning

Figure 26: Dialog Window Detail: Setting for Channel 1

18.

Proceed in the same manner for all additional modules. When parameter

settings are complete, confirm by clicking [OK].

19.

Move the mouse to the entry for the PROFIBUS/HART communications

DTM in the tree structure, select it by clicking with the left mouse button,

and then click Set up connection on the Device menu. The entry for the

communications DTM will now be changed to italics in the tree structure. At

the same time, the BF LED on your PROFIBUS fieldbus coupler will go off.

(You can also carry out the following steps using offline parameterization.

In this case it will also still be possible to set up a connection

retrospectively).

20.

Now move the mouse once again to the entry for the communications DTM

in the tree structure and right click on Add... in the context menu.

Select the HART DTM for your HART field device in the dialog which opens

and confirm the selection by clicking [OK].

A further view will appear in the dialog window in which you can now select

the channel to which your HART device is connected.

21.

Select "M01_Ch01" for Channel 1 of the first plugged-in HART module or

"M01_Ch02" for Channel 2.

Confirm the selection by clicking [OK].

Manual

Version 1.0.2

750-482/000-001 2AI 4-20mA HART NAMUR NE43

WAGO I/O System 750

Table of Contents

Table of Contents