Tcp/Ip Configuration" Page; Table 75: Wbm "Tcp/Ip Configuration" Page - "Tcp/Ip Configuration" Group - WAGO I/O System 750 Manual

WAGO I/O System 750
750-8210/040-000 PFC200; G2; 4ETH; XTR

15.2.1.2.2 "TCP/IP Configuration" Page

The TCP/IP settings for the ETHERNET interfaces are shown on the "TCP/IP
configuration" page.
"TCP/IP Configuration" Group
The properties are displayed in a separate area for each configured bridge.
Table 75: WBM "TCP/IP Configuration" Page – "TCP/IP Configuration" Group
Parameter
Network Details Bridge <n> Settings for the bridge currently configured
Current IP Address
Current Subnet Mask
Current Default Gateway
IP Source
IP Address
Subnet Mask
Default Gateway
Click the [Submit] button to apply a change. The change takes effect
immediately.
Meaning
This displays the current IP address.
This displays current subnet mask.
The IP address of the current default gateway is
displayed.
You can specify whether to use a static or dynamic
IP address.
Static IP Static IP addressing
DHCP Dynamic IP addressing via DHCP
BootP Dynamic IP addressing via BootP
Enter a static IP address. This is enabled if "Static
IP" is enabled in the IP Source field.
Enter the subnet mask. This is enabled if "Static IP"
is enabled in the IP Source field.
Enter the IP address of the default gateway here.
Version 1.7.0, valid from FW Version 04.01.10(23)
Appendix 177
Manual