Table of Contents
Advertisement
68
Commissioning
Figure 35: FDT/DTM Communication via MODBUS TCP/IP
9.2.2
Commissioning 750-841 via FDT/DTM
This section describes the most important steps for commissioning the HART I/O
module on a Controller 750-841 using FDT/DTM.
Along with the fitted and wired fieldbus node hardware, which includes the
connected ETHERNET controller, it is necessary to install the following software
before carrying out the operations described.
Table 35: Software Required for the Commissioning on a 750-841 via FDT/DTM
Pos. Name
1
WAGO-I/O-CHECK
(optional)
2
Default.prg
3
WAGOframe
4
WAGO_Modbus_TCP
_DTM
5
WAGO_075x-08xx_DTM
6
HART device DTM (e.g.,
Generic HART DTM from
ICS GmbH)
1.
When the HART I/O module is delivered it is pre-configured for the default
operating mode (2 AI + 6-byte mailbox).
If this should already have been changed; e.g., if the module has been
used in a PROFIBUS system, the operating mode must be re-
parameterized for the default setting.
To do this, open WAGO-I/O-CHECK, and set the operating mode to
Manual
Version 1.2.0
753-482 2AI 4-20mA 12 Bit S.E. HART
Description
Commissioning tool for the
WAGO-I/O-SYSTEM 750
Special boot project for
Ethernet controllers,
Application note
number:"A116101"
FDT frame application for
parameterization,
commissioning and
diagnostics of devices with
DTM device drivers
DTM for MODBUS/TCP
DTM for the 75x-8xx
controller
DTM for parameterization,
commissioning and
diagnostics of HART-
enabled field devices
WAGO I/O System 750
Item-No.:
759-302
Download:
www.wago.com
759-370
759-359
Both Download:
www.wago.com
Obtainable from
HART field device
manufacturers
Advertisement
Table of Contents
