Configuration Examples - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
l
----End

8.2.15 Configuration Examples

The following sections provide several examples for configuring CFM. Each configuration
example consists of the networking requirements, configuration precautions, and configuration
roadmap.
Context
Example for Configuring Ethernet CFM
In this example, by configuring basic Ethernet CFM, you can implement end-to-end connectivity
fault detection.
Networking Requirements
The Ethernet shown in
B, and Router D. ISP 2 manages Router C, Router E, Router F, Router G, Router H, and Router
I. It is required that connectivity detection be implemented on the network.
Issue 02 (2014-09-30)
Run the display cfm mep [ md md-name [ ma ma-name [ mep-id mep-id ] ] ] command
in any view to check information about a MEP.
Run the display cfm mip [ interface interface-type interface-number | level level ]
command in any view to check information about a MIP.
Run the display cfm remote-mep [ md md-name ma ma-name mep-id mep-id | [ md md-
name [ ma ma-name [ mep-id mep-id ] ] ] ] command in any view to check information
about an RMEP.
Run the display efm session { all | interface interface-type interface-number } command
in any view to check information about the EFM OAM session between the specified
interface and the peer.
NOTE
This document takes interface numbers and link types of the NE40E-X8 as an example. In working
situations, the actual interface numbers and link types may be different from those used in this document.
Figure 8-12
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
is managed by two ISPs. ISP 1 manages Router A, Router
8 Ethernet OAM Configuration
530