Huawei NetEngine80E Configuration Manual - Reliability page 843

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
2.
Issue 02 (2014-09-30)
Information:
*Peer Ip Address
2.2.2.2
PW State
up
Local VC Label
1025
Remote VC Label
1025
PW Type
label
Tunnel ID
0x800003
Broadcast Tunnel ID
0x800003
Broad BackupTunnel ID
0x0
Ckey
0x2
Nkey
0x1
Main PW Token
0x800003
Slave PW Token
0x0
Tnl Type
LSP
OutInterface
GigabitEthernet1/0/2
Backup
OutInterface :
Stp Enable
0
PW Last Up Time
14:19:55
PW Total Up Time
Configure basic Ethernet CFM functions and specify the MEP type as inward.
Configure basic Ethernet CFM functions on each PE. Specify the Ethernet CFM protocol
in the version of IEEE Standard 802.1ag-2007. Create an MD named md1 and an MA
named ma1, and bind the MA to the VSI.
# Configure PE1.
<HUAWEI> system-view
[HUAWEI] sysname PE1
[PE1] cfm enable
[PE1] cfm version standard
[PE1] cfm md md1
[PE1-md-md1] ma ma1
[PE1-md-md1-ma-ma1] map vsi ldp1
[PE1-md-md1-ma-ma1] mep mep-id 1 interface gigabitethernet1/0/1.1 inward
[PE1-md-md1-ma-ma1] mep ccm-send mep-id 1 enable
[PE1-md-md1-ma-ma1] remote-mep mep-id 2
[PE1-md-md1-ma-ma1] remote-mep ccm-receive mep-id 2 enable
[PE1-md-md1-ma-ma1] quit
[PE1-md-md1] quit
# Configure PE2.
<HUAWEI> system-view
[HUAWEI] sysname PE2
[PE2] cfm enable
[PE2] cfm version standard
[PE2] cfm md md1
[PE2-md-md1] ma ma1
[PE2-md-md1-ma-ma1] map vsi ldp1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
:
:
:
:
:
:
:
:
:
:
:
:
:
:
:
: 2010/10/12
: 0 days, 1 hours, 1 minutes, 28 seconds
8 Ethernet OAM Configuration
826