Huawei NetEngine80E Configuration Manual - Reliability page 594

Hide thumbs Also See for NetEngine80E:

Table of Contents

HUAWEI NetEngine80E/40E Router

Configuration Guide - Reliability

Figure 8-18 Networking diagram of configuring VPLS-based Ethernet CFM

Configuration Roadmap

The configuration roadmap is as follows:

Issue 02 (2014-09-30)

Configure the interface mode on each PE to the user termination mode.

Run an IGP to ensure connectivity of routers on the backbone network.

Enable a routing protocol on the backbone network to ensure connectivity of routers and

enable MPLS.

Set up an LSP tunnel between PEs.

Enable MPLS L2VPN on each PE.

Configure a sub-interface for QinQ VLAN tag termination on the AC interface of each PE.

Huawei Proprietary and Confidential

8 Ethernet OAM Configuration

Netengine40e