Huawei NetEngine80E Configuration Manual - Reliability page 840

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Example for Configuring Single-ended Frame Loss Measurement in VPLS
Networking
This section provides an example showing how to configure single-ended frame loss
measurement in VPLS networking.
Networking Requirements
With the increasing popularization and wide application of the Internet, various value-added
services such as IPTV, video conferencing, and VoIP services are widely deployed. Link
connectivity and network performance determine the Quality of Services (QoS) on bearer
networks. Therefore, performance monitoring is especially important for service transmission
channels.
As shown in
are not used to monitor link connectivity, preventing them from using a lot of network bandwidth
resources. To provide high-quality video services, providers hope to monitor the unidirectional
delay over mobile bearer links in real time, while monitoring link connectivity. Monitoring the
unidirectional delay over mobile bearer links allows the providers to respond quickly to video
service quality deterioration.
Issue 02 (2014-09-30)
#
sysname PE2
#
cfm version standard
cfm enable
#
mpls lsr-id 2.2.2.2
mpls
#
mpls l2vpn
#
mpls ldp
#
interface GigabitEthernet1/0/1.1
vlan-type dot1q 2
mpls l2vc 1.1.1.1 2
#
interface GigabitEthernet1/0/2
undo shutdown
ip address 10.1.1.2 255.255.255.0
mpls
mpls ldp
#
interface LoopBack0
ip address 2.2.2.2 255.255.255.0
#
ospf 1
area 0.0.0.0
network 2.2.2.2 0.0.0.0
network 10.1.1.0 0.0.0.255
#
cfm md md1
ma ma1
map mpls l2vc 2 tagged
mep mep-id 2 interface GigabitEthernet1/0/1.1 inward
mep ccm-send mep-id 2 enable
remote-mep mep-id 1
remote-mep ccm-receive mep-id 1 enable
loss-measure single-ended receive mep 2 8021p 1 2
#
return
Figure 8-63, CFM is configured between each CE and PE and between PEs. CCMs
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
823