Huawei NetEngine80E Configuration Manual - Reliability page 115

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
3.
4.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
Procedure
Step 1 Configure IP addresses.
Assign the IP address and mask to each interface according to
details, see "Configuration Files" in this section.
Step 2 Configure E-APS.
1.
2.
Issue 02 (2014-09-30)
Bind static routes to the E-APS-enabled interfaces of PE2 and PE3 and the APS-enabled
interfaces of CE2.
Configure a dynamic routing protocol to import direct routes.
IP addresses of interfaces
E-APS parameters
CPOS-Trunk parameters
Global-MP-Group interface number
Configure APS on PE2, PE3, and CE2.
# Configure PE2.
[PE2] controller cpos 6/2/0
[PE2-Cpos6/2/0] undo shutdown
[PE2-Cpos6/2/0] aps group 24
[PE2-Cpos6/2/0] aps working 4.4.4.4 5.5.5.5
[PE2-Cpos6/2/0] quit
# Configure PE3.
[PE3] controller cpos 1/1/0
[PE3-Cpos1/1/0] undo shutdown
[PE3-Cpos1/1/0] aps group 24
[PE3-Cpos1/1/0] aps protect 4.4.4.4 5.5.5.5
[PE3-Cpos1/1/0] aps mode one2one bidirection
[PE3-Cpos1/1/0] aps revert 1
[PE3-Cpos1/1/0] quit
# Configure CE2.
[CE2] controller cpos3/0/1
[CE2-Cpos3/0/1] undo shutdown
[CE2-Cpos3/0/1] aps group 24
[CE2-Cpos3/0/1] aps working
[CE2-Cpos3/0/1] quit
[CE2] controller cpos3/0/0
[CE2-Cpos3/0/0] undo shutdown
[CE2-Cpos3/0/0] aps group 24
[CE2-Cpos3/0/0] aps protect
[CE2-Cpos3/0/0] aps mode one2one bidirection
[CE2-Cpos3/0/0] aps revert 1
[CE2-Cpos3/0/0] quit
Create a CPOS-Trunk on PE2, PE3, and CE2 and add interfaces to the CPOS-Trunk.
# Configure PE2.
[PE2] interface Cpos-Trunk 24
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
Figure 3-9. For configuration
98