Huawei NetEngine80E Configuration Manual - Reliability page 534

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
----End
Example
In the IEEE Standard 802.1g-2007, run the display cfm md command. If the MD name, MD
name format, MD level, MIP generation rule, and type of the Sender ID TLV are displayed, it
means that the MD is created successfully.
<HUAWEI> display cfm md mdcustomer
MD Name
MD Name Format
Level
MIP Create-type
SenderID TLV-type
MA list
Run the display cfm ma command. If information about the MA is displayed, it means that the
configuration succeeds.
<HUAWEI> display cfm ma md mdcustomer
The total number of MAs is : 1
--------------------------------------------------
MD Name
MD Name Format
Level
MIP Create-type
SenderID TLV-type
MA Name
Interval
Priority
VSI Name
MEP Number
RMEP Number
Run the display cfm mep command. If information about the MEP is displayed, it means that
the configuration succeeds.
<HUAWEI> display cfm mep
The total number of MEPs is : 1
--------------------------------------------------
MD Name
MD Name Format
Issue 02 (2014-09-30)
Run the display cfm remote-mep [ md md-name [ ma ma-name [ mep-id mep-id ] ] ]
command to view detailed information about the RMEP.
Run the display mip create-type [ interface interface-type interface-number ] command
to view the rule for creating the MIP.
Run the display cfm mip [ interface interface-type interface-number | level level ]
command to view information about the MIP.
NOTE
You can run the display mip create-type and display cfm mip commands to view detailed
information about a MIP only after the MIP is created.
: mdcustomer
:
: 2
: none
: defer
:
MA Name
Interval
Vlan ID
L2VC ID
: mdcustomer
:
: 4
: none
: defer
: mdcustomer1
: 1000
: 6
: vsi1
: 1
: 1
: mdcustomer
:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: mdcustomer1
: 1000
: --
: 11
8 Ethernet OAM Configuration
517