Huawei NetEngine80E Configuration Manual - Reliability page 100

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
5.
6.
7.
8.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure IP addresses and an IGP to make PEs routable.
1.
2.
Issue 02 (2014-09-30)
Configure an mPW between PE2 and PE3.
Configure BFD sessions to monitor the primary and secondary PWs.
Configure BFD sessions to monitor mPWs and bind the BFD session to the AC interfaces.
Bind the APS group to BFD sessions.
IP address of each interface
MPLS TE parameters, explicit paths, and tunnel policies
E-APS parameters
PW parameters
BFD parameters
Assign an IP address to every interface.
Configure the IP address and mask of each interface as shown in
configuration procedure is not provided.
Configure an IGP. In this example, IS-IS is used.
# Configure PE1.
[PE1] isis 1
[PE1-isis-1] is-level level-1
[PE1-isis-1] network-entity 1111.1111.1111.1111.00
[PE1-isis-1] graceful-restart
[PE1-isis-1] cost-style wide-compatible
[PE1-isis-1] timer spf 1 1 50
[PE1-isis-1] traffic-eng level-1-2
[PE1-isis-1] quit
[PE1] interface gigabitEthernet 2/0/1
[PE1-GigabitEthernet2/0/1] isis enable 1
[PE1-GigabitEthernet2/0/1] quit
[PE1] interface gigabitEthernet 2/0/2
[PE1-GigabitEthernet2/0/2] isis enable 1
[PE1-GigabitEthernet2/0/2] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
# Configure P1.
[P1] isis 1
[P1-isis-1] is-level level-1
[P1-isis-1] network-entity 2222.2222.2222.2222.00
[P1-isis-1] graceful-restart
[P1-isis-1] cost-style wide-compatible
[P1-isis-1] timer spf 1 1 50
[P1-isis-1] traffic-eng level-1-2
[P1-isis-1] quit
[P1] interface gigabitEthernet 2/0/1
[P1-GigabitEthernet2/0/1] isis enable 1
[P1-GigabitEthernet2/0/1] quit
[P1] interface gigabitEthernet 3/0/2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
Table 3-1. The
83