Huawei NetEngine80E Configuration Manual - Reliability page 636

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
Example for Configuring EFM OAM Extension for Static Routes
In this example, by configuring EFM OAM on CEs and PEs and configuring the PEs with static
routes to the CEs, you can implement the link protection switchover.
Networking Requirements
Figure 8-22
Issue 02 (2014-09-30)
bgp 100
peer 2.2.2.2 as-number 100
peer 2.2.2.2 connect-interface LoopBack1
peer 3.3.3.3 as-number 100
peer 3.3.3.3 connect-interface LoopBack1
#
ipv4-family unicast
peer 2.2.2.2 enable
peer 3.3.3.3 enable
#
ipv4-family vpnv4
policy vpn-target
peer 2.2.2.2 enable
peer 3.3.3.3 enable
#
return
Configuration file of CE1
#
sysname CE1
#
efm enable
#
interface GigabitEthernet1/0/0
undo shutdown
portswitch
port default vlan 10
#
interface GigabitEthernet2/0/0
undo shutdown
portswitch
port default vlan 10
#
interface LoopBack1
ip address 1.1.1.1 255.255.255.255
#
ip route-static 0.0.0.0 0.0.0.0 10.1.1.111
#
return
NOTE
POS interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
shows the networking requirements:
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
619