Maintaining Mpls-Tp Oam; Clearing Mpls-Tp Oam Statistics - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Far-SD2 K Cause
Far-SD2 MN Cause
Near-SD1 Revert Fresh
Far-SD1 Revert Fresh
Near-SD2 Revert Fresh
Far-SD2 Revert Fresh
Near-SD1 Rever Period
Far-SD1 Rever Period
Near-SD2 Rever Period
Far-SD2 Rever Period
[ME 1]
Index
Direction
MEP ID
Remote MEP ID
Status Board
Service Type
UNI-type
Interface-name
Source IP
Netgate MAC
State
local state
Alarm Indicate
Hardware Resouce
GAL
Hardware error info
--------------------------------------------------

9.6 Maintaining MPLS-TP OAM

This section describes how to clear MPLS-TP OAM statistics and detect the MPLS-TP OAM
status by maintaining MPLS-TP OAM.

9.6.1 Clearing MPLS-TP OAM Statistics

Deleting preceding MPLS-TP OAM statistics before you enable MPLS-TP OAM is
recommended.
Context
MPLS-TP OAM statistics cannot be restored after being deleted. Exercise caution when using
the command.
Procedure
l
----End
Issue 02 (2014-09-30)
NOTICE
Run the reset mpls-tp oam meg meg-name statistic-type { lost-measure { single-
ended | dual-ended } | delay-measure { one-way | two-way } command to delete MPLS-
TP OAM statistics.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: No
: No
: No
: No
: No
: No
: -
: -
: -
: -
: 0
: dual
: 1
: -
: 3
: ip
: L2UNI
: GigabitEthernet1/0/1.1
: 10.1.3.1
: 4c1f-cc4a-08d5
: INIT
: Near-End Available
Far-End Available
: no alarm
: -
: 13
: None
9 MPLS-TP OAM Configuration
956