Enabling Bfd Globally; Configuring A Bfd Session - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
No.
1
2

5.8.2 Enabling BFD Globally

You can perform related BFD configurations only after enabling BFD globally.
Context
Perform the following procedure on the router that uses a static BFD session with automatically
negotiated discriminators to detect link faults:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
bfd
BFD is enabled globally and the BFD view is displayed.
----End

5.8.3 Configuring a BFD Session

A static BFD session with automatically negotiated discriminators is configured to rapidly detect
link faults.
Context
Perform the following steps on the router on which a static BFD session with automatically
negotiated discriminators is used to detect link faults:
Perform the following step as required to configure BFD for IPv4 or BFD for IPv6.
Procedure
l
Issue 02 (2014-09-30)
Data
Name of a BFD session
IP addresses of local and remote ends of a link checked by BFD, and name and
number of the local interface
To configured BFD for IPv4,
1. Run:
system-view
The system view is displayed.
2. Run:
bfd bfd-name bind peer-ip ip-address [ vpn-instance-name vpn-name ]
[ interface interface-type interface-number ] source-ip ip-address auto
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 BFD Configuration
344