Huawei NetEngine80E Configuration Manual - Reliability page 744

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Issue 02 (2014-09-30)
NOTE
This task is supported in P2P scenarios.
g. Run:
remote-mep mep-id mep-id
The remote MEP ID is configured.
h. Run:
mep ccm-send enable
The CCM transmission function is enabled.
i. Run:
remote-mep ccm-receive [ mep-id mep-id ] enable
The CCM reception function is enabled.
2. On the receiving device of a PW where single-ended frame loss measurement will
be implemented, run:
Table 8-22 Configurations for enabling the receive end to receive LMMs
Usage Step
Scenario
P2P Non-test instance-based statistics
scenario
Run the loss-measure single-ended receive mep mep-id
command to enable the RMEP to receive LMMs.
Test instance-based statistics
1. Run the test-id test-id command to configure a test instance.
2. Run the loss-measure single-ended receive test-id test-id
command to enable the RMEP to receive LMMs.
P2MP 1. Run the test-id test-id command to configure a test instance for
scenario a specific RMEP.
2. Run the loss-measure single-ended receive test-id test-id
command to enable the RMEP to receive LMMs.
3. On the transmitting device of a PW where single-ended frame loss measurement
will be implemented, run:
Table 8-23 Configurations for enabling a MEP to send LMMs
Usage Step
Scenario
P2P Run the loss-measure single-ended send mep mep-id [ mac mac-
scenario address | remote-mep mep-id ] interval { 1000 | 10000 } count
count-value command to enable on-demand single-ended frame
loss measurement on a PW.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
727