Huawei NetEngine80E Configuration Manual - Reliability page 82

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Figure 3-6 Networking diagram for configuring APS on a CPOS-Trunk
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
Procedure
Step 1 Configure single-chassis APS.
1.
Issue 02 (2014-09-30)
E1 ..
ADM
E1
STM-4/16
ADM
ADM
..
nx E1
Configure single-chassis APS on the two CPOS interfaces, and add the CPOS interfaces
to a CPOS-Trunk.
Bundle timeslots of E1 channels in the CPOS-Trunk to create Trunk-Serial interfaces, and
add the Trunk-Serial interfaces into a Global-MP-Group.
APS parameters
CPOS-Trunk parameters
Global-MP-Group interface number
Configure single-chassis APS on Router A.
<HUAWEI> system-view
[HUAWEI] sysname RouterA
[RouterA] controller cpos 1/0/0
[RouterA-Cpos1/0/0] undo shutdown
[RouterA-Cpos1/0/0] aps group 1
[RouterA-Cpos1/0/0] aps working
[RouterA-Cpos1/0/0] quit
[RouterA] controller cpos 2/0/0
[RouterA-Cpos2/0/0] undo shutdown
[RouterA-Cpos2/0/0] aps group 1
[RouterA-Cpos2/0/0] aps protect
[RouterA-Cpos2/0/0] aps mode one-plus-one unidirection
[RouterA-Cpos2/0/0] quit
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ADM
CPOS-Trunk 0
OC-3/STM-1
3 APS Configuration
RouterA
CPOS 1/0/0
Internet
CPOS 2/0/0
65