Huawei NetEngine80E Configuration Manual - Reliability page 209

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
7.
8.
9.
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
l
l
Procedure
Step 1 Configure an IP address for each interface. The configuration details are not mentioned here.
Configure the IP addresses for the physical interfaces and the loopback interfaces as specified
in Figure
details are not mentioned here.
Step 2 Create eight VE interfaces in four groups on each NPE.
# Configure NPE1.
<HUAWEI> system-view
[HUAWEI] sysname NPE1
[NPE1] interface virtual-ethernet2/0/0
[NPE1-Virtual-Ethernet2/0/0] ve-group 1 l2-terminate
[NPE1-Virtual-Ethernet2/0/0] quit
[NPE1] interface virtual-ethernet2/0/1
Issue 02 (2014-09-30)
Configure the MPLS L3VPN backbone network.
Create the L2VE interface on the NPE to terminate the VPLS, and the L3VE interface to
access L3VPN. Bind them to the same VE-Group.
Configure the basic MPLS functions of the UPEs and NPEs. Set up MPLS LDP sessions
between UPEs and NPEs.
Create an mVSI on the UPE, and connect the NPE to the mVSI through VLL.
Create a service VSI on the UPE, and connect the NPE to the service VSI through VLL.
Run the mVRRP between NPEs. The protocol packets are forwarded between members in
the VRRP backup group by the mVSI on the UPE.
Run the service VRRP between NPEs. Bind the service VRRP to the mVRRP.
Configure the Peer BFD between NPEs; run the Link BFD between NPEs and UPEs. The
mVRRP determines the master or backup status of the routers in the VRRP backup group
according to the status of the Peer BFD and the Link BFD.
Configure the access of CEs to MPLS L3VPN.
Interface number, interface IP address, OSPF process number, OSPF area number, and IS-
IS process number
LSR ID
VSI name and VSI ID
VC ID of VLL
Name of the BFD, the local or remote discriminator, the VRRP backup group number and
priority of VRRP
VE-Group number
Names of VPN instances for MPLS L3VPN
4-19. Run the undo shutdown command to start the interfaces. The configuration
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
192