Huawei NetEngine80E Configuration Manual - Reliability page 139

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
Issue 02 (2014-09-30)
– all: broadcasts a VRRP Advertisement packet to all sub-VLANs of a super VLAN.
NOTICE
The parameter all is not recommended. If all is configured, a super VLAN broadcasts
a VRRP Advertisement packet to all its sub-VLANs. This causes CPU usage to
increase.
Configure the VRRP packet authentication type.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
3. Run:
vrrp vrid virtual-router-id authentication-mode { simple { [ plain ] key
| cipher cipher-key } | md5 md5-key }
The authentication mode for VRRP Advertisement packets is configured.
NOTE
NE80E/40Es in a VRRP backup group must be configured with the same authentication type
and the same authentication key. If different authentication types are configured, the negotiation
on the master and backup states fail.
Configure the VRRP version number.
1. Run:
system-view
The system view is displayed.
2. Run:
vrrp version { v2 | v3 }
VRRP version number is specified.
3. (Optional) Run:
vrrp version-3 send-packet-mode { v2-only | v3-only | v2v3-both }
The mode for sending VRRPv3 Advertisement packets is configured.
Disable VRRP TTL check.
1. Run:
system-view
The system view is displayed.
2. Run:
interface interface-type interface-number
The interface view is displayed.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
122