Enabling The Force Amb/Smb Switchover; Optional) Restarting The Smb - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Step 2 Run:
slave auto-update config
The automatic synchronization of the AMB/SMB configuration is enabled.
If the save command is run on the AMB to save the configuration, the system automatically
updates the configuration on the SMB to synchronize the configurations on the AMB and the
SMB.
By default, the automatic synchronization of configuration data between AMB and SMB is
enabled.
To disable the automatic synchronization of configuration data between AMB and SMB, run
the undo slave auto-update config command.
----End

6.2.4 Enabling the Force AMB/SMB Switchover

The AMB and SMB can be switched to each other after the AMB/SMB switchover is enabled.
Context
Perform the following steps on the GR Restarter:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
slave switchover enable
The force AMB/SMB switchover is enabled.
After the configuration, you can run the slave switchover command to perform the force AMB/
SMB switchover manually.
By default, the force AMB/SMB switchover is enabled.
To disable the force AMB/SMB switchover, run the slave switchover disable command.
----End

6.2.5 (Optional) Restarting the SMB

After the software version on the SMB is upgraded, you can restart the SMB.
Context
During the on-line software upgrade, the SMB software is upgraded when the AMB works
normally. Then, the SMB must be restarted. After the SMB is ready, the AMB/SMB switchover
can be performed.
Perform the following steps on the GR Restarter:
Issue 02 (2014-09-30) Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 GR Configuration
449