Checking The Configurations - Huawei NetEngine80E Configuration Manual - Reliability

Hide thumbs Also See for NetEngine80E:
Table of Contents

Advertisement

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
The BFD session view is displayed.
Step 3 Run:
process-pst
The BFD is permitted to modify the PST.
By default, the BFD does not modify the PST.
If the BFD session on the Trunk member interface or the VLAN member interface allows BFD
to modify the PST, and the main interface is configured with the BFD session, you must configure
the Wait to Recovery (WTR) for the BFD session that detects the main interface. This can prevent
the BFD session on the main interface from flapping when the member interface joins or exits
from the main interface.
For the configuration of the WTR for the BFD session, see
WTR."
Step 4 Run:
commit
The configurations are committed.
----End

5.6.3 Checking the Configurations

By viewing the enabling status of a PST, you can check whether the configurations are
successful.
Prerequisites
The configurations of the BFD to modify the PST function are complete.
Procedure
l
l
----End
Example
After the configuration, running the display bfd session command, you can view that the field
of "Process PST" in the command output is "Enable".
Issue 02 (2014-09-30)
NOTE
l The process-pst command cannot be configured on logical interfaces, such as Eth-Trunk and VLANIF
interfaces.
l After creating a BFD session, if you need to modify session parameters such as process-pst, process-
interface-status, min-tx-interval, min-rx-interval, detect-multiplier, tos-exp (BFD session view),
wtr, and description, you can directly run the corresponding commands without running the
commit command, and the modification takes effect immediately.
Run the display bfd session { all | discriminator discr-value | dynamic | peer-ip peer-
ip [ vpn-instance vpn-instance-name ] | static } [ verbose ] [ slot slot-id ] command to
check the BFD session.
Run the display bfd session { all | static | peer-ipv6 peer-ipv6 [ vpn-instance vpn-instance-
name ] } [ verbose ] [ slot slot-id ] command to check information about the BFD6 session.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 BFD Configuration
"5.11.3 Configuring the BFD
338

Advertisement

Table of Contents
loading

This manual is also suitable for:

Netengine40e

Table of Contents