Huawei NetEngine80E Configuration Manual - Reliability page 75

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Figure 3-5 Networking diagram of configuring TDMoPSN
E12/0/2
2 ×TDM E1
Device
PE1
P
PE2
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
4.
5.
6.
Data Preparation
To complete the configuration, you need the following data:
l
l
Issue 02 (2014-09-30)
E12/0/1
PE1
BTS
Interface
GE 1/0/0
Loopback0
GE 1/0/0
GE 2/0/0
Loopback0
GE 2/0/0
Loopback0
Run the IGP protocol on the backbone network so that devices can communicate with each
other.
Configure basic MPLS functions on the backbone network, as well as the MPLS L2VPN
functions on PE devices. Establish the remote MPLS LDP peer relationship between PEs
at both ends of the PW.
Configure parameters for the TDM interface.
Configure a PW template.
Establish MPLS L2VC connections on PEs.
Configure APS on PE2
L2VC IDs at both ends of the PW (must be the same)
MPLS LSR IDs of the PEs and P device
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/0
GE2/0/0
GE1/0/0 GE2/0/0
P
PWE3 TDM
Transparent Cell Transport
3 APS Configuration
CPOS3/0/1
CPOS3/0/2
PE2
IP Address
10.1.1.1/24
192.2.2.2/32
10.1.1.2/24
10.2.1.1/24
192.4.4.4/32
10.2.1.2/24
192.3.3.3/32
BSC
58