Checking The Configurations; Configuring An Mvrrp Ipv6 Backup Group - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The view of the interface where the VRRP6 backup group is configured is displayed.
Step 3 Run:
vrrp6 vrid backup-forward
The backup device is configured to forward traffic.
----End

4.8.9 Checking the Configurations

You can view the status of the VRRP IPv6 backup group and verify the configuration.
Prerequisites
The configurations of the VRRP IPv6 backup group are complete.
Procedure
l
----End
Example
After successfully configuring the mVRRP IPv6 backup group, run the display vrrp6 command
on the router to view information about the mVRRP IPv6 backup group.
<HUAWEI> display vrrp6
GigabitEthernet1/0/1 | Virtual Router 1

4.9 Configuring an mVRRP IPv6 Backup Group

When multiple VRRP IPv6 backup groups coexist, they can be bound to an mVRRP IPv6 backup
group, decreasing VRRP Advertisement packets to be sent and minimizing network bandwidth
Issue 02 (2014-09-30)
Run the display vrrp6 [ interface interface-type interface-number [ vrid virtual-router-
id ] ] [ brief ] command to check the status and configurations of a specified VRRP IPv6
backup group.
State : Master
Virtual IP : FE80::1
Master IP : 2001:DB8::100
PriorityRun : 100
PriorityConfig : 100
MasterPriority : 100
Preempt : YES Delay Time : 0 s
TimerRun : 100 cs
TimerConfig : 100 cs
Virtual MAC : 0000-5e00-0201
Check hop limit : YES
Config type : normal-vrrp
Create time : 2012-05-19 20:36:40
Last change time : 2012-05-19 20:37:07
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
4 VRRP Configuration
165