Huawei NetEngine80E Configuration Manual - Reliability page 500

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
By default, the local MEP cannot receive CCMs from the RMEP.
When the local device is enabled to receive CCMs from an RMEP, and if connectivity faults are
detected between the local device and the RMEP using CC detection, the local device prompts
alarms of RMEP connectivity.
If mep-id mep-id is not specified, all the MEPs in the MA are enabled to receive CCMs from
all the RMEPs.
----End
Follow-up Procedure
l
l
(Optional) Creating a VLAN
Through the association between a VLAN and default MDs, all interfaces of the specified VLAN
can generate MIPs based on default MDs.
Context
Perform the following steps on each device:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
cfm default md [ level level ]
The default MD is created and the default MD view is displayed.
Step 3 Run:
vlan { vlan-id1 [ to vlan-id2 ] }&<1-10>
The specified VLAN is created.
----End
(Optional) Configuring an MP Address Model
There are two MP address models: individual and shared. The individual MP address model
facilitates fault location and the shared MP address model saves MAC entry storing space.
Context
The 802.1ag standard defines two MP address models:
Issue 02 (2014-09-30)
If you need to enable the CC detection in multiple MAs, repeat
If you need to enable the CC detection in multiple MDs, repeat
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
Step 4 to Step 8.
Step 2 to Step 8.
483