Bit-Error-Triggered Protection Switching Configuration - Huawei NetEngine80E Configuration Manual - Reliability

Hide thumbs Also See for NetEngine80E:

Table of Contents

HUAWEI NetEngine80E/40E Router

Configuration Guide - Reliability

Bit-Error-Triggered Protection Switching

About This Chapter

10.1 Bit-Error-Triggered Protection Switching Overview

Bit-error-triggered protection switching minimizes the impact of line bit errors on broadband

services, improving the reliability of bearer networks.

10.2 Configuring the Association Between Bit Errors and IGP Routes

This section describes how to configure the association between bit errors and IGP routes.

10.3 Enabling Interface-based Bit Error Detection

Interface-based bit error detection reports bit error events and triggers protection switching.

10.4 Configuring Bit-Error-Triggered Trunk Update

This section describes how to configure bit-error-triggered trunk update.

10.5 Configuring Bit-Error-Triggered Section Switching

This section describes how to configure bit-error-triggered section switching.

10.6 Configuring Bit-Error-Triggered RSVP-TE Tunnel Switching

This section describes how to configure bit-error-triggered Resource Reservation Protocol-

Traffic Engineering (RSVP-TE) tunnel switching.

10.7 Configuring Bit-Error-Triggered Switching for PW Redundancy

This section describes how to configure bit-error-triggered switching for pseudo wire (PW)

10.8 Configuring Bit-Error-Triggered VPN Route Switching

This section describes how to configure bit-error-triggered virtual private network (VPN) route

10.9 (Optional) Associating Bit Error Alarms with PW-LSP, E-PW APS, and MS PW Switching

Interface-based bit error detection can trigger bit error alarms, alarm clearing, and PW-LSP, E-

PW APS, and MS PW switching.

10.10 Configuration Examples

Issue 02 (2014-09-30)

10 Bit-Error-Triggered Protection Switching Configuration

Huawei Proprietary and Confidential

Configuration

Netengine40e