Associating Ethernet Cfm With Vpls - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Level
MA Name
MEP ID
L2VC ID
Interface Name
CCM Send
Direction
MAC Address
Run the display cfm remote-mep command. If information about the RMEP is displayed, it
means that the configuration succeeds.
<HUAWEI> display cfm remote-mep
The total number of RMEPs is : 1
The status of RMEPs : 1 up, 0 down
--------------------------------------------------
MD Name
Level
MA Name
RMEP ID
VSI Name
L2VC ID
MAC
CCM Receive
Trigger-If-Down
CFM Status

8.2.10 Associating Ethernet CFM with VPLS

In the VPLS network, you can configure CFM to monitor and manage the connectivity faults of
the link.
Before You Start
Before configuring CFM and VPLS combination, familiarize yourself with the usage scenario,
complete the pre-configuration tasks, and obtain the required data.
Applicable Environment
On the VPLS network shown in
connectivity and implement MAC ping and trace to locate and diagnose faults.
Figure 8-10 Networking diagram for associating Ethernet CFM with VPLS I
Issue 02 (2014-09-30)
: 4
: mdcustomer1
: 4
: 11
: GigabitEthernet1/0/2.1
: enabled
: inward
: 0018-82a0-23a7
: mdcustomer
: 4
: mdcustomer1
: 3
: --
: 11
: 0018-82aa-12ed
: enabled
: disabled
: up
Switch1 CE1
User
Network
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 8-10, CFM can be configured to monitor link
PE1
PE2
VPLS
8 Ethernet OAM Configuration
Switch2
CE2
User
Network
518