Huawei NetEngine80E Configuration Manual - Reliability page 211

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Issue 02 (2014-09-30)
# Configure NPE1.
[NPE1] isis 1
[NPE1-isis-1] network-entity 10.0000.0000.0001.00
[NPE1-isis-1] quit
[NPE1] interface loopback1
[NPE1-LoopBack1] isis enable 1
[NPE1-LoopBack1] quit
[NPE1] interface pos1/0/0
[NPE1-Pos1/0/0] isis enable 1
[NPE1-Pos1/0/0] quit
# Configure NPE2.
[NPE2] isis 1
[NPE2-isis-1] network-entity 10.0000.0000.0002.00
[NPE2-isis-1] quit
[NPE2] interface loopback1
[NPE2-LoopBack1] isis enable 1
[NPE2-LoopBack1] quit
[NPE2] interface pos1/0/0
[NPE2-Pos1/0/0] isis enable 1
[NPE2-Pos1/0/0] quit
# Configure PE3.
<HUAWEI> system-view
[HUAWEI] sysname PE3
[PE3] isis 1
[PE3-isis-1] network-entity 10.0000.0000.0003.00
[PE3-isis-1] quit
[PE3] interface loopback1
[PE3-LoopBack1] isis enable 1
[PE3-LoopBack1] quit
[PE3] interface pos2/0/0
[PE3-Pos2/0/0] isis enable 1
[PE3-Pos2/0/0] quit
[PE3] interface pos3/0/0
[PE3-Pos3/0/0] isis enable 1
[PE3-Pos3/0/0] quit
After the configuration is complete, run the display isis route command. You can view
that the NPEs and PEs can learn the loopback1 route of each other.
Take NPE1 as an example.
[NPE1] display isis route
IPV4 Destination
------------------------------------------------------------------------------
--
5.5.5.9/32
L/-/-
4.4.4.9/32
L/-/-
3.3.3.9/32
L/-/-
10.5.1.0/24
L/-/-
10.6.1.0/24
L/-/-
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Route information for ISIS(1)
-----------------------------
ISIS(1) Level-1 Forwarding Table
--------------------------------
IntCost ExtCost ExitInterface
0 NULL Loop1
10 NULL Pos3/0/0
10 NULL Pos2/0/0
10 NULL Pos2/0/0
10 NULL Pos3/0/0
U-Up/Down Bit Set, C-In Computing
4 VRRP Configuration
NextHop Flags
Direct D/-/
10.6.1.2 A/-/
10.5.1.2 A/-/
Direct D/-/
Direct D/-/
194