Huawei NetEngine80E Configuration Manual - Reliability page 765

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
----End
Checking the Configurations
Run the display y1731 statistic-type twoway-delay md md-name ma ma-name [ 8021p
{ 8021p-value } &<1-3> ] [ count count-value ] command on the device that initiates two-way
frame delay measurement to check statistics about the delay in bidirectional frame transmission.
Run the display y1731 statistic-type command to view statistics about the delay in bidirectional
frame transmission.
<HUAWEI> display y1731 statistic-type twoway-delay md md1 ma ma1
Latest two-way delay statistics of 802.1p 2:
--------------------------------------------------------------------------------
Index
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Average delay(usec) :
Maximum delay(usec) :
Minimum delay(usec) :
Latest two-way delay statistics of 802.1p 3:
--------------------------------------------------------------------------------
Index
--------------------------------------------------------------------------------
--------------------------------------------------------------------------------
Average delay(usec) :
Maximum delay(usec) :
Minimum delay(usec) :
Issue 02 (2014-09-30)
Scenario Procedure
Point-to- 1. Run:
multipoint
2. Run:
NOTE
NOTE
Currently, you can check the configuration of two-way frame delay measurement on in VLL networking
by using the NMS that matches the current device version.
Delay(usec)
1 0
2 0
3 0
Delay(usec)
1 0
2 0
3 0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
test-id test-id mep mep-id [ remote-mep mep-id | mac mac-
address ] [ 8021p 8021p-value ] [ description
description ]
A specific test instance is configured on a peer device.
delay-measure two-way continual send test-id test-id
interval interval
Proactive two-way frame delay measurement is enabled on the
device that is to send DMMs on the PW side.
In point-to-multipoint scenarios, test instance-based statistics collection can be
configured only on a PW-based MEP.
Delay variation(usec)
0 Average delay variation(usec) :
0 Maximum delay variation(usec) :
0 Minimum delay variation(usec) :
Delay variation(usec)
0 Average delay variation(usec) :
0 Maximum delay variation(usec) :
0 Minimum delay variation(usec) :
8 Ethernet OAM Configuration
-
0
0
-
0
0
0
0
0
0
0
0
748