Huawei NetEngine80E Configuration Manual - Reliability page 626

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
Example for Configuring EFM OAM Extension for VRRP
In this example, by configuring EFM OAM on CEs and PEs and configuring a VRRP backup
group on the PEs, you can use the master device to transmit network traffic.
Networking Requirements
As shown in
Issue 02 (2014-09-30)
ip address 3.3.3.3 255.255.255.255
isis enable 1
#
interface Tunnel3/0/0
ip address unnumbered interface LoopBack1
tunnel-protocol mpls te
destination 2.2.2.2
mpls te tunnel-id 200
mpls te path explicit-path npe2-to-npe1
mpls te commit
#
mpls oam egress lsr-id 1.1.1.1 tunnel-id 100 backward-lsp Tunnel3/0/0 private
#
oam-mgr
oam-bind ingress mpls oam lsr-id 2.2.2.2 tunnel-id 200 egress efm interface
GigabitEthernet 1/0/0
#
return
Configuration file of UPE1
#
sysname UPE1
#
efm enable
#
isis 1
is-level level-2
network-entity 00.0005.0000.0000.0005.00
#
interface GigabitEthernet1/0/0
undo shutdown
ip address 100.5.1.2 255.255.255.252
isis enable 1
efm enable
#
interface LoopBack1
ip address 5.5.5.5 255.255.255.255
isis enable 1
#
return
NOTE
POS interfaces cannot be configured on the X1 and X2 models of the NE80E/40E.
Figure 8-21.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
609