Huawei NetEngine80E Configuration Manual - Reliability page 86

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Data Preparation
To complete the configuration, you need the following data:
l
l
l
l
l
Procedure
Step 1 Configure IP addresses and IGP to make PEs routable.
1.
2.
Issue 02 (2014-09-30)
IP address of each interface
MPLS TE of each PE
Parameters necessary for configuring E-APS, such as the WTR time and authentication
string for the PGP message
Parameters of PW.
Parameters of BFD session to detect a PW.
Configure IP addresses on the interfaces.
Assign the IP address and mask to each interface according to
details, see "Configuration Files" in this section.
Configure IGP. In this example, IS-IS is adopted.
# Configure PE1.
[PE1] isis 1
[PE1-isis-1] is-level level-1
[PE1-isis-1] network-entity 1111.1111.1111.1111.00
[PE1-isis-1] graceful-restart
[PE1-isis-1] cost-style wide-compatible
[PE1-isis-1] timer spf 1 1 50
[PE1-isis-1] traffic-eng level-1-2
[PE1-isis-1] quit
[PE1] interface gigabitEthernet 2/0/1
[PE1-GigabitEthernet2/0/1] isis enable 1
[PE1-GigabitEthernet2/0/1] quit
[PE1] interface gigabitEthernet 2/0/2
[PE1-GigabitEthernet2/0/2] isis enable 1
[PE1-GigabitEthernet2/0/2] quit
[PE1] interface loopback 0
[PE1-LoopBack0] isis enable 1
[PE1-LoopBack0] quit
# Configure P1.
[P1] isis 1
[P1-isis-1] is-level level-1
[P1-isis-1] network-entity 2222.2222.2222.2222.00
[P1-isis-1] graceful-restart
[P1-isis-1] cost-style wide-compatible
[P1-isis-1] timer spf 1 1 50
[P1-isis-1] traffic-eng level-1-2
[P1-isis-1] quit
[P1] interface gigabitEthernet 2/0/1
[P1-GigabitEthernet2/0/1] isis enable 1
[P1-GigabitEthernet2/0/1] quit
[P1] interface gigabitEthernet 3/0/2
[P1-GigabitEthernet3/0/2] isis enable 1
[P1-GigabitEthernet3/0/2] quit
[P1] interface loopback 0
[P1-LoopBack0] isis enable 1
[P1-LoopBack0] quit
# Configure P2.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
3 APS Configuration
Figure 3-7. For configuration
69