Huawei NetEngine80E Configuration Manual - Reliability page 523

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
Data Preparation
To associate Ethernet OAM with MPLS OAM or BFD, you need the following data.
No.
1
2
3
4
5
6
7
Configuring Ethernet OAM Functions
You can configure Ethernet OAM between a CE and a PE to detect connectivity faults in
between.
Context
Configure Ethernet OAM to run between CEs and PEs. For details, see "Configuring EFM
OAM" and "Configuring Ethernet CFM".
Associating Ethernet OAM with MPLS OAM or BFD
Ethernet OAM and MPLS OAM or BFD can send fault information to each other.
Context
Perform the following steps on the PEs:
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
oam-mgr
Issue 02 (2014-09-30)
Configure VLL Fast Reroute (FRR) in Martini mode.
Configure the BFD session.
Configure MPLS OAM.
Data
Numbers of the interfaces to be associated
Name of an MD and an MA
IP addresses of interfaces on each piece of equipment, names of tunnel interfaces,
and tunnel IDs
Types of detect packets sent
Ingresses and Egresses of the detected LSP and the backward tunnel
BFD names
Parameters of BFD sessions
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
506