Huawei NetEngine80E Configuration Manual - Reliability page 863

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
Example for Configuring One-way Frame Delay Measurement in VPLS
Networking
This section provides an example showing how to configure one-way frame delay measurement
in VPLS networking.
Issue 02 (2014-09-30)
remote-mep ccm-receive mep-id 2 enable
delay-measure one-way continual send mep 1 remote-mep 2 interval 1000
ma ma2
map mpls l2vc 2 tagged
mep mep-id 4 interface GigabitEthernet1/0/1.1 outward
mep ccm-send mep-id 4 enable
remote-mep mep-id 3
remote-mep ccm-receive mep-id 3 enable
delay-measure one-way receive mep 4
#
return
Configuration file of PE2
#
sysname PE2
#
cfm version standard
cfm enable
#
mpls lsr-id 2.2.2.2
mpls
#
mpls l2vpn
#
vsi ldp1 static
pwsignal ldp
vsi-id 1
peer 1.1.1.1
#
mpls ldp
#
interface GigabitEthernet1/0/1.1
vlan-type dot1q 2
mpls l2vc 1.1.1.1 2
#
interface GigabitEthernet1/0/2
undo shutdown
ip address 10.1.1.2 255.255.255.0
mpls
mpls ldp
#
interface LoopBack0
ip address 2.2.2.2 255.255.255.0
#
ospf 1
area 0.0.0.0
network 2.2.2.2 0.0.0.0
network 10.1.1.0 0.0.0.255
#
cfm md md1
ma ma1
map mpls l2vc 2 tagged
mep mep-id 2 interface GigabitEthernet1/0/1.1 inward
mep ccm-send mep-id 2 enable
remote-mep mep-id 1
remote-mep ccm-receive mep-id 1 enable
delay-measure one-way receive mep 2
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
846