Huawei NetEngine80E Configuration Manual - Reliability page 219

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Issue 02 (2014-09-30)
An NPE does not need to learn the MAC addresses of other NPEs, so it is recommended
that NPEs connect to the mVSIs on UPEs through VLL. The VC ID must be the same as
the ID of the VSI that the NPE accesses.
# Configure NPE1.
[NPE1] mpls l2vpn
[NPE1-l2vpn] mpls l2vpn default martini
[NPE1-l2vpn] quit
[NPE1] interface virtual-ethernet2/0/0.1
[NPE1-Virtual-Ethernet2/0/0.1] vlan-type dot1q 1
[NPE1-Virtual-Ethernet2/0/0.1] mpls l2vc 1.1.1.9 10
[NPE1-Virtual-Ethernet2/0/0.1] quit
[NPE1] interface virtual-ethernet2/0/2.1
[NPE1-Virtual-Ethernet2/0/2.1] vlan-type dot1q 1
[NPE1-Virtual-Ethernet2/0/2.1] mpls l2vc 2.2.2.9 20
[NPE1-Virtual-Ethernet2/0/2.1] quit
# Configure NPE2.
[NPE2] mpls l2vpn
[NPE2-l2vpn] mpls l2vpn default martini
[NPE2-l2vpn] quit
[NPE2] interface virtual-ethernet2/0/0.1
[NPE2-Virtual-Ethernet2/0/0.1] vlan-type dot1q 1
[NPE2-Virtual-Ethernet2/0/0.1] mpls l2vc 1.1.1.9 10
[NPE2-Virtual-Ethernet2/0/0.1] quit
[NPE2] interface virtual-ethernet2/0/2.1
[NPE2-Virtual-Ethernet2/0/2.1] vlan-type dot1q 1
[NPE2-Virtual-Ethernet2/0/2.1] mpls l2vc 2.2.2.9 20
[NPE2-Virtual-Ethernet2/0/2.1] quit
After the configuration is complete, run the display vsi name verbose command on UPEs.
You can view that the Administrator VSI in the output is yes, and the VSI State in the
output is up.
Take UPE1 as an example.
[UPE1] display vsi name admin-vsi1 verbose
***VSI Name
Administrator VSI
Isolate Spoken
VSI Index
VSI State
Resource Status
Run the display mpls l2vc command on NPEs. You can view that the VC State in the
output is up.
Take NPE1 as an example.
[NPE1] display mpls l2vc
total LDP VC : 2
*Client Interface
Administrator PW
session state
AC status
VC state
VC ID
VC type
VC type
destination
local VC label
control word
forwarding entry
local group ID
manual fault
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
: admin-vsi1
: yes
: disable
: 0
: up
: Valid
2 up 0 down
: Virtual-Ethernet2/0/0.1
: no
: up
: up
: up
: 10
: vlan
: ethernet
: 1.1.1.9
: 140289 remote VC label
: disable
: exist
: 0
: not set
4 VRRP Configuration
: 148480
202