Huawei NetEngine80E Configuration Manual - Reliability page 83

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
2.
Step 2 Configure the CPOS-Trunk.
1.
2.
3.
4.
Step 3 Verify the configuration.
# Run the display aps group command on Router A to view the APS configuration. The
command output shows the working interface, protection interface, and switchback WTR time.
[RouterA] display aps group 1
APS Group
------------------------------------------------------------------------
Group Work-Channel Protect-Channel Wtr W-State P-State Switch-Cmd Switch-Result
------------------------------------------------------------------------
1
------------------------------------------------------------------------
total entry: 1
# Run the display cpos-trunk command to view the CPOS-Trunk configuration. The command
output shows the status of CPOS-Trunk member interfaces.
Issue 02 (2014-09-30)
Create a CPOS-Trunk on Router A and add CPOS interfaces to the CPOS-Trunk.
[RouterA] interface cpos-trunk 0
[RouterA-Cpos-Trunk0] quit
[RouterA] controller cpos 1/0/0
[RouterA-Cpos1/0/0] cpos-trunk 0
[RouterA-Cpos1/0/0] quit
[RouterA] controller cpos 2/0/0
[RouterA-Cpos2/0/0] cpos-trunk 0
[RouterA-Cpos2/0/0] quit
Bundle timeslots of E1 channels in the CPOS-Trunk.
[RouterA] interface cpos-trunk 0
[RouterA-Cpos-Trunk0] e1 1 unframed
[RouterA-Cpos-Trunk0] e1 2 unframed
[RouterA-Cpos-Trunk0] quit
Create a Global-MP-Group.
[RouterA] interface global-mp-group 0
[RouterA-Global-Mp-Group0] shutdown
[RouterA-Global-Mp-Group0] quit
Add Trunk-Serial interfaces to the Global-MP-Group.
[RouterA] interface Trunk-Serial0/1:0
[RouterA-Trunk-Serial0/1:0] shutdown
[RouterA-Trunk-Serial0/1:0] link-protocol ppp
[RouterA-Trunk-Serial0/1:0] ppp mp-global global-mp-group 0
[RouterA-Trunk-Serial0/1:0] quit
[RouterA] interface Trunk-Serial0/2:0
[RouterA-Trunk-Serial0/2:0] shutdown
[RouterA-Trunk-Serial0/2:0] link-protocol ppp
[RouterA-Trunk-Serial0/2:0] ppp mp-global global-mp-group 0
[RouterA-Trunk-Serial0/2:0] quit
Restart Trunk-Serial interfaces and the Global-MP-Group.
[RouterA] interface global-mp-group 0
[RouterA-Global-Mp-Group0] undo shutdown
[RouterA-Global-Mp-Group0] quit
[RouterA] interface Trunk-Serial0/1:0
[RouterA-Trunk-Serial0/1:0] undo shutdown
[RouterA-Trunk-Serial0/1:0] quit
[RouterA] interface Trunk-Serial0/2:0
[RouterA-Trunk-Serial0/2:0] undo shutdown
[RouterA-Trunk-Serial0/2:0] quit
1: Cpos1/0/0 working channel 1(Active)
Cpos2/0/0 protection channel 0(Inactive)
Unidirectional, 1+1 mode, Revert time(6 minutes)
No Request on Both Working and Protection Side
Cpos1/0/0 Cpos2/0/0
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
6 ok ok
3 APS Configuration
NA idle
66