Huawei NetEngine80E Configuration Manual - Reliability page 608

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
l
l
Procedure
Step 1 Configure the interface mode on each PE to the user termination mode.
# Configure PE1.
<HUAWEI> system-view
[HUAWEI] sysname PE1
[PE1] interface gigabitethernet 2/0/0
[PE1-GigabitEthernet2/0/0] mode user-termination
[PE1-GigabitEthernet2/0/0] undo shutdown
[PE1-GigabitEthernet2/0/0] quit
# Configure PE2.
<HUAWEI> system-view
[HUAWEI] sysname PE2
[PE2] interface gigabitethernet 2/0/0
[PE2-GigabitEthernet2/0/0] mode user-termination
[PE2-GigabitEthernet2/0/0] undo shutdown
[PE2-GigabitEthernet2/0/0] quit
Step 2 Enable an IGP on the MPLS backbone network. OSPF is adopted in this example.
Assign an IP address to each interface on each PE and the P router as shown in
After OSPF is enabled, the 32-bit loopback addresses of PE1, P, and PE2 must be advertised.
# Configure PE1.
[PE1] interface loopback 1
[PE1-LoopBack1] ip address 1.1.1.9 32
[PE1-LoopBack1] quit
[PE1] interface gigabitethernet 1/0/0
[PE1-GigabitEthernet1/0/0] ip address 10.1.1.1 24
[PE1-GigabitEthernet1/0/0] undo shutdown
[PE1-GigabitEthernet1/0/0] quit
[PE1] ospf
[PE1-ospf-1] area 0
[PE1-ospf-1-area-0.0.0.0] network 1.1.1.9 0.0.0.0
[PE1-ospf-1-area-0.0.0.0] network 10.1.1.0 0.0.0.255
[PE1-ospf-1-area-0.0.0.0] quit
[PE1-ospf-1] quit
# Configure the P router.
<HUAWEI> system-view
[HUAWEI] sysname P
[P] interface LoopBack 1
[P-LoopBack1] ip address 2.2.2.9 32
[P-LoopBack1] quit
[P] interface gigabitethernet 1/0/0
[P-GigabitEthernet1/0/0] ip address 10.1.1.2 24
[P-GigabitEthernet1/0/0] undo shutdown
[P-GigabitEthernet1/0/0] quit
[P] interface gigabitethernet 2/0/0
[P-GigabitEthernet2/0/0] ip address 10.1.2.1 24
Issue 02 (2014-09-30)
L2VC IDs on both ends of the PW (They must be the same.)
MPLS LSR ID of each PE and the P router
IP address of the remote peer of each PE
Tag value that is terminated on the sub-interface for QinQ VLAN tag termination
Name and level of each MD, name of each MA, MEP ID, name of the interface on which
the MEP resides, and type of the MEP
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
Figure 8-19.
591