Huawei NetEngine80E Configuration Manual - Reliability page 908

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Figure 8-74 Single-ended SLM in VLAN networking
Network
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure single-ended on-demand SLM.
1.
Issue 02 (2014-09-30)
CE1
User
GE1/0/1
Configure single-ended on-demand SLM on a link between customer edges (CEs).
Configure single-ended proactive SLM on a link between CEs.
ID of the VLAN to which the CEs belong
Names of the maintenance domain (MD) and maintenance association (MA) in which CE1
and CE2 reside
Configure basic Ethernet connectivity fault management (CFM) functions and set the
maintenance association end point (MEP) type to outward.
Configure basic Ethernet CFM functions on each CE. Specify the Ethernet CFM protocol
as IEEE Standard 802.1ag-2007. Create an MD named md3 and an MA named ma3, and
bind the MA to the VLAN.
# Configure CE1.
[CE1] vlan 2
[CE1] interface gigabitethernet1/0/1
[CE1-GigabitEthernet1/0/1] portswitch
[CE1-GigabitEthernet1/0/1] port link-type trunk
[CE1-GigabitEthernet1/0/1] port trunk allow-pass vlan 2
[CE1-GigabitEthernet1/0/1] quit
[CE1] cfm md md3
[CE1-md-md3] ma ma3
[CE1-md-md3-ma-ma3] map vlan 2
[CE1-md-md3-ma-ma3] mep mep-id 3 interface gigabitethernet1/0/1 outward
[CE1-md-md3-ma-ma3] mep ccm-send mep-id 3 enable
[CE1-md-md3-ma-ma3] remote-mep mep-id 4
[CE1-md-md3-ma-ma3] remote-mep ccm-receive mep-id 4 enable
[CE2-md-md3-ma-ma3] test-id 1 mep 3 remote-mep 4
# Configure CE2.
<HUAWEI> system-view
[HUAWEI] sysname CE2
[CE2] vlan 2
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
GE1/0/1
PE1
PE2
VLL/VPLS
/VLAN
8 Ethernet OAM Configuration
CE2
User
Network
CE3
User
Network
891