Huawei NetEngine80E Configuration Manual - Reliability page 212

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
2.
Issue 02 (2014-09-30)
IPV4 Destination
------------------------------------------------------------------------------
--
5.5.5.9/32
L/-/-
4.4.4.9/32
3.3.3.9/32
10.5.1.0/24
L/-/-
10.6.1.0/24
L/-/-
Flags: D-Direct, A-Added to URT, L-Advertised in LSPs, S-IGP Shortcut,
Configure the basic MPLS functions and LDP on the backbone network.
# Configure NPE1.
[NPE1] mpls lsr-id 3.3.3.9
[NPE1] mpls
[NPE1-mpls] quit
[NPE1] mpls ldp
[NPE1-mpls-ldp] quit
[NPE1] interface pos1/0/0
[NPE1-Pos1/0/0] mpls
[NPE1-Pos1/0/0] mpls ldp
[NPE1-Pos1/0/0] quit
# Configure NPE2.
[NPE2] mpls lsr-id 4.4.4.9
[NPE2] mpls
[NPE2-mpls] quit
[NPE2] mpls ldp
[NPE2-mpls-ldp] quit
[NPE2] interface pos1/0/0
[NPE2-Pos1/0/0] mpls
[NPE2-Pos1/0/0] mpls ldp
[NPE2-Pos1/0/0] quit
# Configure PE3.
[PE3] mpls lsr-id 5.5.5.9
[PE3] mpls
[PE3-mpls] quit
[PE3] mpls ldp
[PE3-mpls-ldp] quit
[PE3] interface pos2/0/0
[PE3-Pos2/0/0] mpls
[PE3-Pos2/0/0] mpls ldp
[PE3-Pos2/0/0] quit
[PE3] interface pos3/0/0
[PE3-Pos3/0/0] mpls
[PE3-Pos3/0/0] mpls ldp
[PE3-Pos3/0/0] quit
After the configuration is complete, LDP sessions can be set up between PE3 and the NPEs.
Run the display mpls ldp session command. You can view that the "Status" in the output
is "Operational".
Take PE3 as an example.
[PE3] display mpls ldp session
LDP Session(s) in Public Network
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
ISIS(1) Level-2 Forwarding Table
--------------------------------
IntCost ExtCost ExitInterface
0 NULL Loop1
10 NULL
10 NULL
10 NULL Pos2/0/0
10 NULL Pos3/0/0
U-Up/Down Bit Set, C-In Computing
4 VRRP Configuration
NextHop Flags
Direct D/-/
Direct D/-/
Direct D/-/
195