Huawei NetEngine80E Configuration Manual - Reliability page 616

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
l
Example for Associating EFM OAM with MPLS OAM
In this example, through the association between EFM OAM and MPLS OAM, the EFM OAM
sessions can send fault information to each other through Ethernet CFM.
Networking Requirements
On the provider network shown in
links; UPEs and NPEs are connected through Ethernet links.
The requirements are as follows:
Issue 02 (2014-09-30)
#
interface GigabitEthernet1/0/0.1
undo shutdown
vlan-type dot1q 10
ip address 10.1.1.1 255.255.255.0
#
return
Configuration file of CE2
#
sysname CE2
#
interface GigabitEthernet1/0/0.1
undo shutdown
vlan-type dot1q 10
ip address 10.1.1.2 255.255.255.0
#
return
Configuration file of Switch1
#
sysname Switch1
#
vlan batch 100
#
interface GigabitEthernet1/0/0
undo shutdown
port trunk allow-pass vlan 100
#
interface GigabitEthernet1/0/1
undo shutdown
port vlan-stacking vlan 10 stack-vlan 100
#
return
Configuration file of Switch2
#
sysname Switch2
#
vlan batch 100
#
interface GigabitEthernet1/0/0
undo shutdown
port trunk allow-pass vlan 100
#
interface GigabitEthernet1/0/1
undo shutdown
port vlan-stacking vlan 10 stack-vlan 100
#
return
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Figure 8-20, NPEs and P are connected through Ethernet
8 Ethernet OAM Configuration
599