Maintaining Efm - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
oam-mgr
The OAM management view is displayed.
Step 3 You can perform either of the following operations as required:
l Run the oam-bind ingress efm interface interface-type interface-number egress mpls
l Run the oam-bind ingress mpls oam { lsp-name lsp-name | lsr-id ingress-lsr-id tunnel-
----End

8.3.7 Maintaining EFM

This section describes how to maintain EFM, involving EFM debugging.
Debugging EFM
In routine maintenance, run debugging commands in any view to view the operating status of
EFM.
Context
Debugging affects system performance. After debugging is complete, run the undo
debugging command to disable it immediately.
When an EFM fault occurs, run the debugging command in the user view to debug EFM, and
locate and analyze the fault.
Issue 02 (2014-09-30)
Configure basic EFM functions.
Configure basic MPLS OAM functions.
oam interface tunnel tunnel-number command to configure EFM to notify MPLS OAM of
faults.
id tunnel-id } egress efm interface interface-type interface-number command to configure
MPLS OAM to notify EFM of faults.
NOTICE
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
8 Ethernet OAM Configuration
672