Example For Configuring Single-Hop Bfd6 For A Layer 3 Physical Link - Huawei NetEngine80E Configuration Manual - Reliability

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
l
l
5.17.14 Example for Configuring Single-hop BFD6 for a Layer 3
Physical Link
This example describes how to configure single-hop BFD6 for a Layer 3 physical link to monitor
and rapidly detect faults in the IPv6 link between two directly-connected devices.
Networking Requirements
On the network shown in
direct link between Router A and Router C.
Figure 5-17 Networking diagram of single-hop BFD6 for a Layer 3 physical link
RouterA
Issue 02 (2014-09-30)
#
return
Configuration file of Switch 1
#
sysname Switch1
#
vlan batch 100
#
interface GigabitEthernet1/0/0
undo shutdown
port vlan-stacking vlan 10 stack-vlan 100
#
interface GigabitEthernet1/0/1
undo shutdown
port trunk allow-pass vlan 100
#
interface GigabitEthernet1/0/2
undo shutdown
port trunk allow-pass vlan 100
#
return
Configuration file of Switch 2
#
sysname Switch2
#
vlan batch 10
#
interface GigabitEthernet2/0/0
undo shutdown
port default vlan 10
#
interface GigabitEthernet1/0/0
undo shutdown
port trunk allow-pass vlan 10
#
return
Figure
GE1/0/0
2001:db8::1/64
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5-17, BFD in asynchronous mode is set to detect faults in the
2001:db8::2/64
5 BFD Configuration
RouterB
GE1/0/0
431