Example For Connecting A Sub-Interface Enabled With Single-Tag Vlan Mapping To A Vpls Network - Huawei Quidway S7700 Configuration Manual - Ethernet

Quidway S7700 Smart Routing Switch
Configuration Guide - Ethernet
5.12.13 Example for Connecting a Sub-interface Enabled with
Single-Tag VLAN Mapping to a VPLS Network
Networking Requirements
As shown in
is connected to PE2. CE1 and CE2 belong to the same VSI. LDP is used as the VPLS signaling
protocol to set up the PW and Martini VPLS is configured to enable CE1 and CE2 to
communicate with each other.
Figure 5-13 Networking diagram for configuring Martini VPLS
PE 1
GE1/0/0
GE1/0/0
Switch
PE1
PE2
Issue 01 (2011-07-15)
port hybrid pvid vlan 30
port hybrid tagged vlan 30
#
interface GigabitEthernet2/0/0
#
interface GigabitEthernet2/0/0.1
control-vid 2000 qinq-termination
qinq termination pe-vid 100 ce-vid 10
l2 binding vsi a2
#
interface LoopBack1
ip address 3.3.3.9 255.255.255.255
#
ospf 1
area 0.0.0.0
network 3.3.3.9 0.0.0.0
network 169.1.1.0 0.0.0.255
#
return
Figure 5-13, VPLS is enabled on PE1 and PE2. CE1 is connected to PE1 and CE2
Loopback1
1.1.1.9/32
GE 2/0/0
GE 2/0/0
CE 1
Interface
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
GigabitEthernet1/0/0
GigabitEthernet2/0/0
Loopback1
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Loopback1
2.2.2.9/32
GE 1/0/0
GE1/0/0
P
Martini
VLANIF interface
GigabitEthernet1/0/0.1
VLANIF 20
-
VLANIF 30
GigabitEthernet2/0/0.1
-
5 QinQ Configuration
Loopback1
3.3.3.9/32
PE 2
GE 2/0/0
GE 1/0/0
CE 2
IP address
-
168.1.1.1/24
1.1.1.9/32
169.1.1.2/24
-
3.3.3.9/32
280