Huawei NetEngine80E Configuration Manual - Reliability page 46

HUAWEI NetEngine80E/40E Router
Configuration Guide - Reliability
Figure 2-5 Networking diagram of Configuring Load Balancing interface backup
RouterA
10.10.1.2/24
Configuration Roadmap
The configuration roadmap is as follows:
1.
2.
3.
Data Preparation
To complete the configuration, you need the following data:
l
l
Procedure
Step 1 Configure the network layer attributes.
# Configure IP addresses of all interfaces as shown in
For configuration details, see "Configuration Files" in this section.
# Configure a static route to Host B network segment on Router A.
<RouterA> system-view
[RouterA] ip route-static 10.20.1.0 255.255.255.0 pos1/0/0
[RouterA] ip route-static 10.20.1.0 255.255.255.0 pos2/0/0
[RouterA] ip route-static 10.20.1.0 255.255.255.0 Pos3/0/0
# Configure a static route to Host A network segment on Router B.
<RouterB> system-view
[RouterB] ip route-static 10.10.1.0 255.255.255.0 pos1/0/0
Issue 02 (2014-09-30)
POS1/0/0
10.1.1.1/24
POS2/0/0
10.1.2.1/24
GE4/0/0
POS3/0/0
10.1.3.1/24
HostA
10.10.1.1/24
Configure POS 2/0/0 on Router B as the active interface.
Configure POS 1/0/0 and POS 3/0/0 in the interface view of POS 2/0/0 as the standby
interfaces. POS 1/0/0 has a higher priority.
Configure the threshold of the load balancing percentage and the active interface
bandwidth.
The priority of the standby interface
The threshold of the load balancing percentage and the active interface bandwidth
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 Interface Backup Configuration
POS1/0/0
10.1.1.2/24
POS2/0/0
10.1.2.2/24
RouterB
GE4/0/0
POS3/0/0
10.20.1.2/24
10.1.3.2/24
HostB
10.20.1.1/24
Figure 2-5.
29