3Com Router 3000 Ethernet Family
Configuration Guide
Chapter 2 User Configuration Interface
2.1 Setting up Configuration Environments
The system supports both local and remote configuration. The following subsections
tell you how to set up the configuration environments.
2.1.1 Setup through the Console Port
Step 1: To set up a local configuration environment, connect the serial port on a PC (or
terminal) to the console port on the router using a standard RS-232 cable, as shown in
Figure 2-1.
Console
Console
Router
Router
Figure 2-1 Set up a local configuration environment through the console port
Step 2: Run the terminal emulation program (Win9X HyperTerminal for example) on the
PC, and set the terminal communication parameters as follows:
Bits per second: 9600
Data bits: 8
Stop bits: 1
Parity: None
Flow control: None
TermType: VT100
See Figure 2-2 through Figure 2-4.
Set up a local configuration environment
Set up a local configuration environment
Console
Console
cable
cable
PC
PC
RS-232 serial port
RS-232 serial port
3Com Corporation
Chapter 2 User Configuration Interface
2-1