Boot Process Of The Rpu2 - 3Com 6000 series Getting Started Manual

34 Chapter 3: Starting and Configuring the Router 6000
Boot Process of the
RPU2
Checking/Operating after power-on
After powering on the router, check that:
The LEDs on the front panel show that the router is operating
■
normally.
For description on LED behaviors, refer to the section "Generic Modules".
The console terminal displays normally.
■
After you power on the router, you can see the startup banner (refer to
the section "Boot Process of the RPU2"). After the boot process or
power-on self-test (POST) completes, press <Enter> as prompted and
proceed to configure the router when the command line prompt
<3Com> appears.
The Boot ROM runs at startup of the router. The terminal displays the
following banner:
The banner varies by Boot ROM version.
System starts booting ... (1.01)
*******************************************
*
* 3Com 6000 Router, 10.05
*
*******************************************
Copyright© 2003-2004 by 3COM-3COM TECH CO., LTD.
Compiled at Wed Jul 20 16:35:23 EDT 2005
Testing memory...OK!
512M bytes SDRAM Memory
Hardware Version is 2.0
CPLD Version is 1.0
Press Ctrl-B to enter Boot Menu
Press <Ctrl+B> to have the system enter Boot Menu. Otherwise, the
system starts decompressing the program and displays:
System is
self-decompressing......................................
OK!
*
*
*
0