16. FUSER UNIT / PAPER EXIT SECTION
16.1 General Description
Toner is fused by applying heat and pressure on the transferred image on the paper which is trans-
ported to the fuser unit. The paper is then transported to the inner tray, paper exiting options or ADU.
The fuser unit consists of the IH coil (IH-COIL), fuser roller, pressure roller, fuser belt, separation roller,
separation fingers, separation plate, cleaning roller, oil roller, thermistors (THM1, 2, 3), thermostat
(THMO1), exit roller, exit sensor (S40), discharge brush, etc.
Exit roller
Separation plate
Cleaning roller
Oil roller
Thermostat
Thermistor
June 2005 © TOSHIBA TEC
Separation roller
Fuser roller
IH coil
Fig.16-1
e-STUDIO281c/351c/451c FUSER UNIT / PAPER EXIT SECTION
16 - 1
05/08
Exit sensor
Fuser belt
Discharge brush
Separation finger
Pressure roller
16