Ricoh C211 Service Manual page 765

BULLETIN NUMBER:
APPLICABLE MODEL: VT2130
SUBJECT: EJECT ROLLERS
SYMPTOM:
1. Master eject jams.
2. Dislodged Master Eject Belt.
CAUSE:
1. The current configuration of the Master Eject
Rollers creases the edges of the Master.
2. The operator removes the jammed Master roughly.
SOLUTION:
To prevent the ejected Master from creasing (resulting in a Master eject jam), the 2 outside sets of rollers of
the 1st Upper and 1st Lower Eject Rollers have been moved inward 20mm for improved contact with the
Master and the following changes have been implemented.
1) The Bottom Plate of the Master Eject Unit has been changed (the guides for the 2 rollers,
which are fixed to the Bottom Plate, have been moved.)
2) The positions of the E-rings that fix the rollers to the Upper Pulley Shaft have been moved.
3) The Pressure Plate has been changed (the cutouts corresponding with the Eject Rollers have been
moved).
OLD PART NEW PART
NO. NO.
C2013530 C2113531
C2003539 C2113549
C2003542 C2113552
C2033527 C2113535
C2003708 C2113709
UNITS AFFECTED:
All VT2130 Priports manufactured after Serial Number C211408XXXX will have the new style Eject Rolle rs,
Upper Pulley Shaft, Bottom Plate and Pressure Plate installed during production.
SS830/950/VT2130-044
DESCRIPTION
Upper Pulley Shaft
1st Upper Eject Roller
1st Lower Eject Roller
Bottom Plate-Master Eject
Pressure Plate
Old
New
The outermost rollers have been moved in 20mm
QTY INT
1 1 3
1 1 3
1 1 3
1 1 3
1 1 1
11/08/94
REFERENCE
PAGE ITEM
59 35
"1"
59 8
AS
59 6
A
SET
61 14
61 17