Ricoh C211 Service Manual page 295

PCRIP-10. (If the Priport is not On Line, the scanner in the Priport will be
enabled instead.) If the green On Line light comes on, skip to Step 8.
7. If the On Line light does not come on, check to see that the new ROM
was installed as described in Step 5 and is seated firmly in its socket. Try
the On Line key again. If the On Line light comes on, skip to Step 8. If
not, contact your local service organization for help.
8. Turn the PCRIP-10 off. Install the Diagnostic Plug P/N DP000001
(optional test tool) in the port labeled Diagnostic on the rear of the
PCRIP-10 and turn it back on again. The PCRIP-10 will send an internal
PostScript file to the Priport which will output a Diagnostic Status page.
This page includes PostScript font samples as well as configuration
status from the PCRIP-10. (An example of this page can be found on
page 6-35 of the Priport Controller User's Guide.)
9. The configuration status information found in the lower left corner of the
page should match the following factory default settings:
Selected Page Size: US Letter (in US and Canada) or A4 (International)
Controller RAM size: 4 Megabytes
Mode: Postscript Compatibility
(The number which follows "Controller Firmware Rev:" will vary according
to when the PCRIP-10 was manufactured. This firmware revision number
will be needed only if you must contact your local service organization
about technical problems with this PCRIP-10 unit.)
Now that you have verified that the PCRIP-10 can successfully send
files to the Priport, you are ready to proceed with configuring the
PCRIP-10. Turn to page 6-23 of the User's Guide to continue.
FSM 6-11 VT2105