Ricoh C211 Service Manual page 133

4. IMAGE SHIFTING SECTION
4.1 ENCODER MOUNTING POSITION ADJUSTMENT
[c]
'm
Purpose:
1.
2.
3.
4.
To ensure that the image is positioned
Shifting key is set at the center "O".
[A]
in the middle when the Image
Remove the rear cover of the machine.
Turn on the power switch and press the "-" Image Shifting key to shift the
position to the maximum backward position ("-2" position). After that, press
"+" Image Shifting key to shift the position to the center (when the "O"
position LED lights).
Make sure that it is possible to insert the image shifting position gauge [A] to
confirm gear alignment and, therefore, the image shifting position.
If incorrect, adjust the gear alignment as follows after removing the encoder
[B] , .
CAUTION: Adjust the encoder position after removing the connector [C]
of the image shift motor.
5-21