Ricoh C211 Service Manual page 311

The following selections are available in the "File" menu: Print a File, Eject
Page, Info About this Program and Quit (Exit) this Program. To print an
output file from the hard disk or a diskette as a test of the configuration
before saving or exiting the program, you would use the "Print a File"
command. To clear the Input Buffer of the Controller or to create a master for
a blank page, you would use the "Eject Page" command. To check the
revision number of the PCRIP program which you are using, you would
choose "Info About this Program ". You may also exit the program from this
menu.
The following selections are available in the "Special" menu: Set Inter-Job
Timeout Value, Disable Formfeed between Jobs, Enable Formfeed
between Jobs and Enter Executive Mode. The factory default setting for
Inter-Job Timeout Value is 20 seconds. In other words, if the Controller does
not receive any data from the computer for more than 20 seconds, the
Controller will assume that the print job is complete and signal the start of
master making in the Priport. Some software applications, specifically
Windows-based programs which generate graphic-intensive output, may
require a longer timeout value. If you use the "Set Inter-Job Timeout Value "
to change this setting, we recommend that you increase the timeout value in
10 second increments until you achieve the desired output results. The
factory default setting also has Formfeed Enabled. If the PCL-5 output file
does not include a formfeed, the Controller will automatically generate one.
You may turn this feature off with "Disable Formfeed between Jobs" and
turn it back on with "Enable Formfeed between Jobs ". This menu also
provides an advanced PostScript feature called "Executive Mode" which
allows direct entry of PostScript programming commands from the keyboard
of the computer.
6.14 CONFIGURATION OF MACINTOSH COMPUTERS
The utility disk contains a program called "FontDownLoader" and 13 small
PostScript format files. These files contain the instructions for changing the
output page size, printing the diagnostic status page, saving configuration
changes permanently and numbering multiple Controllers if more than one
Controller is connected to the same AppleTalk network. (If you will be
changing the output page size regularly, you should copy the entire PCRIP
Utility folder onto your desktop or hard disk.)
-
The files which will be used most frequently are the output page size
selection files. They are "A4", "B4", "B5", "US Letter" and "US Legal".
FSM 6-27 VT2105