Ricoh C211 Service Manual page 615

3.
Adjusting The Ciearance of
The Exit Pawi
/
..3-...+
[A]
Purpose : To ensure that the printing paper is delivered without paper wrap or damage
to
Method : 1.
2.
3.
4.
5.
the screen.
Remove the rear cover of the machine (6 screws).
With a (1Omm) open end wrench, gradually rotate the drum rotation shaft while
manually activating the paper feed solenoid to feed a sheet of paper and
manually activate the printing pressure solenoid to move the exit pawl [A] to
the drum.
Make sure that the clearance between the drum and the exit pawl is 0.3 to
0.5 mm when the exit pawl is at the position closest to the drum.
If incorrect, open the master eject box and loosen the hexagon nut [B] of
the exit pawl drive arm. Then adjust the clearance by turning the screw
[c] .
Confirm this adjustment by repeating steps 2 and 3.
5-75 Rev. 8189
.,