Ricoh C211 Service Manual page 151

7.2 PAPER TABLE HEIGHT ADJUSTMENT
Purpose: Toensure smooth paper feed.
1.
2.
3,
5
6,
7,
Set the paper feed pressure adjusting lever to the upper position.
Remove the front cover of the machine,
Access 1/0 check mode (See page 4-1 1).
" Enter "O"in the memory display and "4" in the copy counter.
Press the Print Start key to raise the paper table.
After the paper table stops, insert a scale into the slot at the end of the paper
table, Make sure that the distance between the lower stay [A] and the upper
face of the table is 147.5 to 148.5 mm.
If not, loosen the screw [B] and
After adjustment, repeat step 5
several times,
adjust the position of the actuator [C].
again by lowering and raising the paper table
NOTE: When mounting the actuator, make sure that the actuator does not
contact the paper table height sensor [D].
5-39